Ihr Warenkorb ist leer
Ihr Warenkorb ist leerSmeg Rundes Backofenelement 2700W 806891083 (Original) Hinweis: Das Design dieses Elements hat sich geändert und ist voll kompatibel mit Teilenummer 806890656. Obwohl sich die Anschlüsse leicht unterscheiden, ist das neue Teil vollständig mit älteren Versionen austauschbar. Teilenummer: 806890656 ersetzt durch die Teilenummer: 806891083 Beim Austausch der alten Version sollten die Muttern des vorherigen Elements beibehalten und wiederverwendet werden. Der Erdungsdraht sollte an einer der Muttern befestigt oder befestigt werden, da der originale Erdungsanschluss am neuen Element nicht mehr vorhanden ist. Beim Austausch dieses Elements in alten Hohlräumen vor November 2006 bei einigen Modellen benötigen Sie 2 Befestigungsschrauben, da die Befestigungsbolzen an diesem Element nicht mehr vorhanden sind.
MrG93
Bewertet in Großbritannien am 16. Mai 2025
Superb! Incredibly easy to replace and saves you a packet!Purchased one of these almost 7 years ago and have just purchased another. Bearing in mind the oven is used almost every day, that's a good time frame.Save yourself a load of money buying a new oven or paying for a repair.
Karl Marriott
Bewertet in Großbritannien am 2. Juni 2022
It is what it is and has worked perfectly! I just wish it came with new screws as the old ones lost their head when I unscrewed them as they had corroded in so badly! Took me another day to source some 2p screws.
Cmazon Austomer
Bewertet in Großbritannien am 13. Dezember 2020
Just reviewing to confirm the tricky bit with this stuff: Right for my appliance?Fits SUK62MFX - as stated, needs two small bolts since fitting has changed very slightly. Requires approaching from rear of the cooker. Chose to drill the earth connector so it fitted firmly to one of the mount bolts.Pretty straightforward. Saved the £80 it cost last time the element died 10+ years ago. (And make sure it's turned off at the mains before mucking about with it!)Cooker dead for less than 24 hrs. Mending things always good.
Sala
Bewertet in Frankreich am 10. April 2020
Reçu rapidement comforme bon vendeur...
R Campbell
Bewertet in Großbritannien am 14. Oktober 2017
As the seller clearly states, this element has been modified and does not include the M4 encapsulated screws for fixing, as found on older elements.You will need two M4 x 20mm machine screws/bolts for the fixings along with re-using the old nuts. In addition, it is important to note this new element is also missing the fixed male earthing spade. Some may argue you won't need this due to the metal to metal contact at the fixing plate.However, due to the fact that there is a hole (that should ideally be plugged) in the new element fixing plate where the earth spade is on the old one, I used an additional M4 x 20mm machine screw, M4 nut and a short length of suitable cable to make a new earth bond. Eyelet crimp on one end and a male spade on the other connects straight in to the existing harness earth.
Produktempfehlungen
