Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Monument tap reseater
Schneidet die Sitze von undichten Bändern neu.
Passend für BS5412 & BS1010 1/2 Zoll und 3/4 Zoll Wasserhähne.
Komplett mit:
17, 19 25 mm (11/16 Zoll 3/4 Zoll 1 Zoll) Flachschneider und zwei doppelseitige Kunststoffbuchsen.
Rob
Bewertet in Großbritannien am 4. November 2024
Simple and well made. Worked really well re-seating my Deva kitchen taps, no more drips.
Richard
Bewertet in Großbritannien am 29. November 2023
This is a decent enough tool and will get the job of reseating your tap done OK. It comes with a decent range of plastic threads to fit different tap sizes, these work well enough with a bit of care. There are also three cutters supplied. Perhaps my tap seat was pretty far gone but personally I found they made pretty hard work of restoring my tap seat to good order, more like 30 turns than six. After quite a bit of work and a new washer my tap did not drip so it has done the job. For occasional use this is OK but I'm sure regular users will pay a bit more to get something a little better.
Don Hughes
Bewertet in den USA am10. August 2022
Not very effective.
Yves POUILLAUDE
Bewertet in Frankreich am 2. September 2017
Bien, mais les fraises pourraient être plus efficaces. Elles pourraient être des rayons du cercle au lieu d'être des cordes
LaVern Strause
Bewertet in den USA am13. Oktober 2015
It did the trick, just as advertised. It's now part of my tool box.
Produktempfehlungen
164.22€
66 .99 € 66.99€