Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Nennspannung: DC 12V
Reduktionsverhältnis: 1:101
Leerlaufgeschwindigkeit: 60RPM
Nenndrehmoment: 7Kg.cm
Nennstrom: 1400/1320mA (positive Rotation bei negativer Rotation)
Fehler: ±10%
D geformte Ausgangswelle Größe: 8*15mm (0.31" x 0.59") (D*L)
Getriebegröße: 58.1 x 40.11 x 36mm (2.29" x 1.58" x 1.42") (L*W*H)
Motorgröße: 31 x 57.2mm (1.22" x 2.25") (D*L)
Montagelochgröße: M4 (nicht im Lieferumfang enthalten)
Hauptmaterial: Metall, elektronische Komponente
Drahtlänge: 20cm
Pakete:
– 1 x Schneckengetriebemotor
Frank
Bewertet in den USA am7. Januar 2025
I use the gear motor to rotate a solar drum composter. The gear motor has been working for over a year and has a runtime of two hours daily. The needed torque in this application is close to the manufacturer's highest recommended torque. I greased the gearbox with plenty of Timken wheel-bearing grease.
Dalamar
Bewertet in den USA am6. Juli 2024
Used this with the shaft mount adaptor. Worked great
Richard Raines
Bewertet in den USA am24. November 2024
To power a robot movement.
Roger
Bewertet in den USA am9. Juli 2023
It is the same worm drive motor in the Rite Hight system for your active target or live scope
Charlie C
Bewertet in den USA am18. Mai 2022
+ Seemed somewhat robust- Doesn't run well at low speeds under PWM control.- Whistles under PWM control using Arduino Uno OC2A/OC2B outputs to drive L298 H-bridge.- Vibrates a lot at full speed, even when run with DC. Unmounted (held in hand) this isn't an issue. When attached to something that functions as a sounding board it seems quite loud.Maybe I can cobble together a sound/vibration dampening mounting system.EDIT 5/19/22: I finally figured out how to use Arduino PWM properly. In phase-correct PWM mode the motor was controllable using a 33khz cycle frequency and a L298 H-bridge. The motor/gearing noise remains at high speeds (if 5rpm can be considered high speed), but all traces of PWM squealing are gone, and speed can be lowered to the point where it's almost imperceptible. So I raised my rating a star. I would have gone to 5 stars but there's a tiny amount of backlash/slop in the output shafts and it's noisier than I would have liked.
Produktempfehlungen
