Ihr Warenkorb ist leer
Ihr Warenkorb ist leerTanaka
Bewertet in Frankreich am 3. März 2024
Coupe très bien pour des siporex épaisseur 100mm
Bugsmi
Bewertet in Frankreich am 27. September 2024
Parfait pour le ittong
Kunde
Bewertet in Deutschland am 3. März 2022
Gutes Produkt wenn mann es nicht allzuoft benutzt. Ich denke dass die Lebensdauer nicht sehr lange ist bei häufiger Verwendung.
Julia M
Bewertet in Deutschland am 20. Januar 2022
Klasse Säge die geht echt durch wie Butter bei dünnen Porenbetonsteinen. Für einer Durchreiche habe ich sogar 24cm tiefe Steine damit zersägt. Hat wohl bei der Länge der Klinge ein wenig gedauert aber es hat trotzdem funktioniert.
Markus S
Bewertet in Deutschland am 9. September 2021
Qualität ist gut, sagt schnell und ohne großen Kraftaufwand. Die Schnitte werden gerade und bisher sehe ich auch keinen Verschleiß.Würde ich wieder kaufen
FB
Bewertet in Deutschland am 31. März 2021
Ich hatte mir die Säge gekauft, um einen Porenbetonblock in mehrere Scheiben zu schneiden. Das ging mit dieser Säge sehr gut. Sie liegt gut in der Hand. Für mich hierfür das optimale Werkzeug.
a
Bewertet in Großbritannien am 8. Mai 2020
This is a good saw and does what it’s designed for. I’ve so far only used it on dense aerated blocks. What I would add is I found it easier to cut if the blocks were wet. As tried to cut some while dry and then another batch after we had had rain.In the end I did resort to using the saw to score a 2-5 mm line all around and used the traditional chisel and hammer to break them. This resulted in a much cleaner break than using a hammer and chisel and also saved effort and time.Really doesn’t create a lot of dust, obviously not as quick as an angle grinder, but with that you get the dust.Just to update as my picture shows on light aerated blocks it cuts through like butterI’d buy again if I needed too. Will try it on some slate paving slabs as well
Peet
Bewertet in Deutschland am 24. Juni 2020
diese Säge funktioniert besser als erwartet... gut ich hab nicht viel zu sägen, aber das was ich Säge wird gut.... ich kann nicht meckern...Der Kraftaufwand ist auch relativ gering... durch die geringe Sägegeschwindigkeit hat man ordentlich Kontrolle über den Schnitt.
Sebastian
Bewertet in Deutschland am 3. September 2019
Leider ist das Sägeblatt nach 30 Steinen stumpf 🤔 bis dahin lief sie gut durch!!
Martin Woodhouse
Bewertet in Großbritannien am 12. Mai 2019
I just erected a security room out of dense blocks 12 feet high. The last course left a gap around 100mm between the wall top and the concrete ceiling of the workshop I built it in. Now, to build the wall itself I had to cut dense blocks to length using a 9 inch grinder with diamond blade which I did outside as I went, but oh, the dust storm from each one and on a factory estate. I made an effort to saw on windless days but my neighbours still got dust on their cars. Now faced with sawing at least 25 blocks lengthwise presented a real dust problem. I had some leftover grey celcon blocks from a previous job and saw this saw (excuse the pun). It seemed to have fairly good reviews so I ordered it. I positioned myself outside with a workstand and timed my effort. I can report that sawing a lightweight block with this saw takes about 1 minute and produced zero dust that I should be concerned about. It goes through celcon like a hot knife through butter. I did try it on a dense block but I can report that it had little to no effect and that you would probably just ruin the saw. The saw came exactly as pictured, in good time. If you are into building out of celcon etc, this is a must have tool and should last my lifetime. It is well engineered and just the right size and very ergonomic.
Thomas Zimmermann
Bewertet in Deutschland am 11. Mai 2019
Macht was es soll
Mr Crisp
Bewertet in Großbritannien am 12. November 2016
Bought one of these to cut aircrete blocks because my old Irwin panel saw was struggling (it's meant for wood).The item received looks different to the picture because it's got a black blade with an orange handle, but that's not really relevant as I bought it for it's performance, not its aesthetics.The blade is very heavy duty steel, much heavier than an equivalent wood saw, doubt you'd could bend it much if at all.The teeth are very hard and sharp, and it cuts through aerated concrete blocks very easily. Speeds up work on site no end when compared to a standard handsaw.Handle feels well attached to the saw blade, no discernible movement between them.
Sammy4547
Bewertet in Deutschland am 24. Februar 2014
Manchmal verstehe ich einige Leute/Bewertungen. Ich benötigte eine dieser Spezialsägen, da ich eine aus Ytong gemauerte Wand kürzen musste. Auf Grund der Bewertung vor mir war ich mir nicht sicher, pb es nur diese Säge sein soll.Und ich kann jetzt sagen... Es war die richtige Entscheidung!ich musste wie oben geschrieben eine Abseitenwand kürzen. Auf Grund des etwas beengtem Rraumes wollte ich eine kurze Säge und keine 600mm. Meine Ytong-Steine waren ungefähr 15cm dick und ca. 20-25cm hoch. Zusätzlich war/ist die Wand mit Kalkputz verputz gewesen. Ich hatte null Probleme und für diesen Einsatz war die Säge bestens geeignet!Liebe Leute versucht zumindest in kurzen Worten zu beachreiben wofür ihr das Pridukt benötigt habt.Das ich mir keine 400mm Säge für nen 400mm Stein kaufe ist logisch. Aber ohne jegliche Angaben von euch, helfen zumindest mir die Bewertungen nicht weiter bzw schrecken einen zurück!Ich hoffe meine Bewertung kann ein wenig mehr Klarheit schaffen...
Produktempfehlungen